Configuring Tcp/Ipv6 Network Settings - Canon ipf8300 User Manual

Hide thumbs Also See for ipf8300:

Table of Contents

Network Setting

Execute the following command to send the IP address to the printer and configure it.

ping [IP address as specified in the ARP command] -l 479

Example: ping xxx.xxx.xxx.xxx -l 479

• The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and de-

fault gateway to match your network settings.

For details on RemoteUI, see "Using RemoteUI."

Configuring TCP/IPv6 Network Settings

When printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control Panel.

Follow the steps below to configure the TCP/IPv6 network settings.

On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (

Press the OK button.

The Set./Adj. Menu is displayed.

Press ▲ or ▼ to select Interface Setup, and then press the OK button.

Press ▲ or ▼ to select TCP/IP, and then press the OK button.

Press ▲ or ▼ to select IPv6, and then press the OK button.

Press ▲ or ▼ to select IPv6 Support, and then press the OK button.

Press ▲ or ▼ to select On, and then press the OK button.

Configuring TCP/IPv6 Network Settings

Downloaded from ManualsPrinter.com Manuals

Network Setting

• In -l, the l is the letter l.

• In Mac OS X when using Terminal, enter the ping command in the format

ping -s 479 xxx.xxx.xxx.xxx.

For details, refer to the help file for the command line.

• If the Tab Selection screen is not displayed, press the Menu button.