End Of Paper Feed; Rel Lever Is In Wrong Position; Rewinding Error; Media Take-Up Unit Ready - Canon ipf8300 User Manual
Hide thumbs
Also See for ipf8300:
- Basic manual (52 pages) ,
- Setup manual (16 pages) ,
- Brochure (4 pages)
Table of Contents
Advertisement
End of paper feed.
You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit.
Rel lever is in wrong position.
Cause
The Release Lever is up.
Rewinding error.
There is some foreign object near the Media Take-up Unit sensor
and the roll cannot be detected.
The Media Take-up Unit sensor is soiled and the roll cannot be de-
tected.
The roll is out of range of detection by the Media Take-up Unit sen-
sor.
The Media Take-up Unit sensor is damaged.
A paper jam has occurred and the roll cannot be rewound.
*Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to
stop, set Skip Take-Up Err to On. However, note that this error may cause paper jams and affect the printing
quality.
Media take-up unit ready.
The Take-up Reel setting in the printer Set./Adj.
Menu was changed from Enable to Disable, but a
print job was received before the roll was re-
moved.
iPF8300
Downloaded from ManualsPrinter.com Manuals
Cause
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Cause
Cause
Error Message
Corrective Action
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
(See "Loading Rolls in the Printer.")
Contact your Canon dealer for assistance.
Remove the paper from the Media Take-up Unit.
Press the OK button to clear the error.
Corrective Action
Press ▲ or ▼ to select Stop Printing, and then press the OK
button to stop printing.
The mode switches from take-up mode to regular mode after you
change the Take-up Reel setting in the Set./Adj. Menu from En-
able to Disable and lift the Release Lever to remove a roll, or af-
ter you execute Paper Cutting.
Press ▲ or ▼ to select Print, and then press the OK button to
resume printing.
>
Messages regarding paper
Corrective Action
Release the ▲ button.
Release the ▲ button.
Corrective Action
→P.777
End of paper feed.
>
13
1091
Advertisement
Table of Contents
Troubleshooting
