Configuring Islb Initiator Names Or Ip Addresses - Cisco MDS 9000 series Configuration Manual
Nx-os ip services multilayer switches
Hide thumbs
Also See for MDS 9000 series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Configuring iSLB
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
•
•
•
•
Configuring iSLB Initiator Names or IP Addresses
You must specify the iSLB initiator name or IP address before configuring it.
Specifying the iSLB initiator name or IP address is the same as for an iSCSI initiator. See the
Note
Mapping" section on page
To enter iSLB initiator configuration submode using the name option for an iSLB initiator, follow these
steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# islb initiator name
iqn.1987-02.com.cisco.initiator
switch(config-islb-init)#
switch(config)# no lslb initiator name
iqn.1987-02.com.cisco.initiator
To enter iSLB initiator configuration submode using the ip-address option for an iSLB initiator, follow
these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# islb initiator
ip-address 10.1.1.3
switch(config-islb-init)#
switch(config)# no islb initiator
ip-address 10.1.1.3
switch(config)# islb initiator
ip-address 2001:0DB8:800:200C::417A
switch(config-islb-init)#
switch(config)# no islb initiator
ip-address 2001:0DB8:800:200C::417A
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
4-42
Making the Dynamic iSLB Initiator WWN Mapping Static, page 4-43
Assigning VSAN Membership for iSLB Initiators, page 4-44
Configuring Metric for Load Balancing, page 4-45
Verifying iSLB Initiator Configuration, page 4-45
Verifying iSLB Authentication Configuration, page 4-49
Configuring and Activating Zones for iSLB Initiators and Initiator Targets, page 4-46
Configuring iSLB Session Authentication, page 4-48
Verifying iSLB Authentication Configuration, page 4-49
4-13.
Purpose
Enters configuration mode.
Configures an iSLB initiator using the iSCSI name of
the initiator node (iqn.1987-02.com.cisco.initiator) and
enters iSLB initiator configuration submode. The
maximum name length is 223 alphanumeric characters.
The minimum length is 16.
Deletes the configured iSLB initiator.
Purpose
Enters configuration mode.
Configures an iSLB initiator using the IPv4 address of
the initiator node and enters iSLB initiator configuration
submode.
Deletes the configured iSLB initiator.
Configures an iSLB initiator using the IPv6 unicast
address of the initiator node and enters iSLB initiator
configuration submode.
Deletes the configured iSLB initiator.
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Chapter 4
Configuring iSCSI
"Static
Advertisement
Table of Contents
