Creating Fcip Links - Cisco MDS 9000 series Configuration Manual
Nx-os ip services multilayer switches
Hide thumbs
Also See for MDS 9000 series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Example 2-2
switch# show fcip profile 7
FCIP Profile 7
Creating FCIP Links
When two FCIP link endpoints are created, an FCIP link is established between the two IPS modules or
MPS-14/2 modules. To create an FCIP link, assign a profile to the FCIP interface and configure the peer
information. The peer IP switch information initiates (creates) an FCIP link to that peer switch (see
Figure
Figure 2-10
Connecting switch (peer) = 10.1.1.1
IP address of Gigabit Ethernet
interface 3/1 = 10.100.1.25
To create an FCIP link endpoint in switch 1, follow these steps:
Command
Step 1
switch1# config terminal
switch(config)#
Step 2
switch1(config)# interface fcip 51
switch1(config-if)#
Step 3
switch1(config-if)# use-profile 10
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
2-10
Displays the Specified FCIP Profile Information
Internet Address is 47.1.1.2 (interface GigabitEthernet4/7)
Listen Port is 3225
TCP parameters
SACK is disabled
PMTU discovery is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 300 ms
Maximum number of re-transmissions is 4
Send buffer size is 0 KB
Maximum allowed bandwidth is 1000000 kbps
Minimum available bandwidth is 15000 kbps
Estimated round trip time is 1000 usec
2-10).
Assigning Profiles to Each Gigabit Ethernet Interface
Endpoint
Interface FCIP = 51
Profile = 10
Switch 1
FCIP link
Switch 1
IP router
Endpoint
Interface FCIP = 52
Profile = 20
Connecting switch (peer) = 10.100.1.25
Virtual (E) ISL
IP router
IP
network
IP address of Gigabit Ethernet
Purpose
Enters configuration mode.
Creates an FCIP interface (51).
Assigns the profile (10) to the FCIP interface.
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Chapter 2
Configuring FCIP
Switch 2
Switch 2
interface 3/1 = 10.1.1.1
Advertisement
Table of Contents
