Remove Blanking Panels - Cisco ASR 5000 Series Installation Manual
Hide thumbs
Also See for ASR 5000 Series:
- Product overview (992 pages) ,
- Administration manual (509 pages) ,
- Thresholding configuration manual (163 pages)
Table of Contents
Advertisement
Preparing a Full-Height Line Card Slot
Remove Blanking Panels
You must remove the half-height blanking panels covering the upper and lower chassis slots, if installed.
Step 1
Identify the chassis slots in which the full-height line card will be installed.
Step 2
Use a Phillips #2 screwdriver to loosen the screws at the top and bottom of the blanking panel. Hold the screws on the
blanking panel, and pull the blanking panel away from the chassis to expose the chassis slot.
Step 3
Repeat step 2 to remove the half-height blanking panel covering the chassis slot directly below the slot exposed in the
previous step.
Caution:
reduces airflow through the chassis, which could cause it to overheat. Install a card or a blanking panel s in every
chassis slot.
On a powered up chassis, do not leave chassis slots uncovered for extended periods of time. This
Remove Blanking Panels ▀
ASR 5000 Installation Guide ▄
293
Advertisement
Table of Contents
