Install And Remove Transceiver Module; Safety Precautions For Module Installation And Removal - Cisco Network Convergence System 540 Hardware Installation Manual

Large density routers

Table of Contents

Install the Device

Install and Remove Transceiver Module

This section shows how to install and remove transceiver module.

Be sure to observe the following safety precautions when you work on the chassis.

Warning

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to

ensure that the system remains stable. The following guidelines are provided to ensure your safety:

• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the

heaviest component at the bottom of the rack.

• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the

unit in the rack.

This product is a Class 1 laser product.

Do not stare into the beam or view it directly with optical instruments.

Invisible laser radiation is present.

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

An instructed person is someone who has been instructed and trained by a skilled person and takes the necessary

precautions when working with equipment.

A skilled person or qualified personnel is someone who has training or experience in the equipment technology

and understands potential hazards when working with equipment.

Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089 for

the definition of a skilled person.

Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide

Install and Remove Transceiver Module

Table of Contents