Table of Contents
Advertisement
Chapter 2 Alarm Troubleshooting
Note
Step 7
If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
2.6.132 LWBATVG
The LWBATVG condition is not used in this platform in this release. It is reserved for development.
2.6.133 MAN-REQ
The Manual Switch Request condition occurs when a user initiates a Manual switch request on an
STM-N port. Clearing the Manual switch clears the MAN-REQ condition. You do not need to clear the
switch if you want the manual switch to remain.
Clear the MAN-REQ Condition
Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
2.6.134 MANRESET
A Manual System Reset condition occurs when you right-click a TSC card, SSXC card, or traffic
(STM-N) card in CTC and choose Hard-reset Card or Soft-reset Card.
The hard-reset option is enabled only when the card is placed in the Locked-enabled,maintenance
Note
service state.
2.6.135 MANSWTOINT
July 2010
If ports managed into Unlocked administrative state are not receiving signals, the LOS alarm is
either raised or remains, and the port service state transitions to Unlocked-disabled,failed.
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: VCMON-HP
"Initiate a 1+1 Protection Port Manual Switch Command" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Objects: EQPT, PIM, PPM
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: NE-SREF
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2.6.132 LWBATVG
2-124.
2-91
Advertisement
Table of Contents
Troubleshooting
