Table of Contents
Advertisement
Chapter 4 Error Messages
Table 4-1
Error Messages (continued)
Error Warning
ID
Error Warning Message
EID-6055
The IP address is already in use.
EID-6056
The SNMP trap destination is invalid. {0}
WID-6057
Changing the card mode will result in an automatic reset.
EID-6058
The maximum number of IP-over-CLNS tunnels has been
exceeded.
EID-6059
The specified IP-over-CLNS tunnel already exists!
EID-6060
An error occurred while trying to {0} an IP-over-CLNS tunnel
entry:
{1}.
EID-6061
An error occurred while deleting the IP-over-CLNS tunnel
entry.
EID-6062
The selected IP-over-CLNS tunnel does not exist.
EID-6063
The selected router does not exist.
EID-6064
The MAA address list is full.
EID-6065
The selected area address is duplicated.
EID-6066
The primary area address cannot be removed.
EID-6067
The selected area address does not exist.
EID-6068
The IP-over-CLNS NSEL cannot be modified while there are
IP-over-CLNS tunnel routes provisioned.
EID-6069
The node is currently in ES mode. Only Router 1 can be
provisioned.
EID-6070
No router was selected.
EID-6071
The TARP data cache cannot be flushed.
EID-6072
The TARP data cache entry cannot be added:
{0}
WID-6073
A TARP request has been initiated.
Try refreshing the TARP data cache later.
EID-6074
End system mode only supports one subnet.
EID-6075
An error occurred while trying to remove a MAT entry. The
entry does not exist.
EID-6076
An error occurred while trying to {0} a TARP manual
adjacency entry:
{1}
EID-6077
The area address must be between 1 and 13 bytes long,
inclusive.
EID-6078
A TDC entry with this TID {0} does not exist in the table.
July 2010
Description
Refer to the error message text.
The specified SNMP trap destination is
invalid. Choose another destination.
Refer to the warning message text.
Refer to the error message text.
Specify another IP-over-CLNS tunnel.
Refer to the error message text.
CTC encountered an error while deleting
the IP-over-CLNS tunnel entry.
Create a IP-over-CLNS tunnel.
Create a router.
Refer to the error message text.
Enter another area address.
Refer to the error message text.
Choose another area address.
You cannot change the NSEL address if
tunnels are provisioned.
An end system needs only one provisioned
router.
Select a router.
You cannot flush the cache in the Target
Identifier Address Resolution Protocol
(TARP) state.
You cannot add the specified cache entry.
Refer to the warning message text.
Refer to the error message text.
CTC is removing the MAT entry.
CTC cannot add the specified adjacency
entry for reasons unknown.
The area address should not be more than 13
characters.
The specified target identifier does not
exist.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-41
Advertisement
Table of Contents
Troubleshooting
