Panasonic UF-6300 Service Manual page 122
Hide thumbs
Also See for UF-6300:
- Operating instructions manual (166 pages) ,
- Operating instructions manual (100 pages) ,
- Operating instructions manual (166 pages)
Table of Contents
Advertisement
Code
Mode
Phase
570
RCV
571
XMT
580
XMT
581
XMT
601
XMT
623
XMT
630
XMT or
RCV
(Polling)
631
XMT
634
XMT
638
XMT
711
RCV
712
XMT
714
XMT
RCV
715
XMT
716
XMT
717
XMT
Fax Information Codes
Description of Problem
B
Password or machine code did not
match during remote diagnostic
communication.
B
Remote unit did not have the
remote diagnostic function.
B
Sub-address transmission to a unit
that has their DIS bit 49 (NSF bit
155) OFF.
B
Sub-address Password
transmission to a unit that has their
DIS bit 50 (NSF bit 156) OFF.
ADF Door was opened during ADF
transmission.
A
No original was in the ADF. (Built-in
dialer engaged)
B
Redial count over.
A
"STOP" button was pressed during
Auto Dialing.
B
Redial count over with no response
or busy tone was not detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
LAN
Power turned off with applicable
data in memory or during
communication.
LAN
Incorrect LDAP settings.
LAN
Unknown email address replied
from the Mail Server.
LAN
LAN Interface error.
Cannot logon to the LAN.
LAN
TCP/IP connection timed out.
LAN
Cannot logon to the LAN.
LAN
Incomplete SMTP Protocol
transmission.
Sub-address transmission to a unit that
has no Sub-address function.
Sub-address transmission to a unit that
has no Sub-address function.
Operator removed the original from the
ADF after dialing was completed.
Original was not set properly in the
ADF.
No dial tone detected. Sensor dial tone
is not detected. (destination dependent)
Busy tone is detected. (destination
dependent) T1 timer (35±5 sec.)
elapsed without a signal from the
receiver.
Telephone line cable is disconnected.
Wrong number is dialed.
SC or MJR PCB is abnormal.
Power cord unplugged. Power failure
occurred.
LDAP Server Name, LDAP Login
Name, LDAP Password and/or LDAP
Search Base are incorrect.
Mail Server received an incorrect email
address. (Dependent on Server's Mail
application)
The 10Base-T/100Base-TX cable is not
connected.
An unexpected LAN problem occurred.
Check the LANC/LANB PCB connector.
Incorrect IP Address is set.
Verify the IP Address, Default Router IP
Address, SMTP Server IP Address.
Incorrect SMTP Server IP Address is
set.
No email application is activated on the
Mail Server.
Mail Server's hard disk may be full.
Mail Server is defective.
122
Cause
Hide quick links:
Advertisement
Table of Contents
