Panasonic UF-6300 Service Manual page 119
Hide thumbs
Also See for UF-6300:
- Operating instructions manual (166 pages) ,
- Operating instructions manual (100 pages) ,
- Operating instructions manual (166 pages)
Table of Contents
Advertisement
Code
Mode
Phase
200
RCV
212
XMT
RCV
301
XMT
RCV
331
XMT
390
STANDBY
RCV
PRINT
400
XMT
401
XMT
402
XMT
403
RCV
(Polling)
404
XMT
405
XMT
406
RCV
(Password
Comm.)
407
XMT
408
XMT
Fax Information Codes
Description of Problem
C
Decoding process is not completed
at the end of phase C.
A-E
Interface error occurred between
the CPU and modem.
-
System fault.
C
8-minutes timer error.
(Germany only)
-
Interface error occurred between
the machine and the PC.
B
T1 timer (35±5 sec.) elapsed
without detecting 300 bps signal.
B
DCN was returned from receiver
while transmitter is waiting for CFR
or FTT.
B
DCN was returned from receiver
while transmitter is waiting for NSF/
DIS.
B
Transmitter had no polling function. "POLLED=ON" (polling XMT ready) is
B
Transmitter sent NSS (or DCS)
followed by TCF three times, but
the receiver did not respond. (CFR
or FTT is usually returned)
B
Transmitter received FTT after it
transmitted TCF at 2400bps.
Received RTN after communicating
at 2400 bps.
B
XMT-Password mismatched.
RCV-Password mismatched.
Selective RCV incomplete.
D
Transmitter received no response
after it transmitted post message,
such as EOP, MPS, EOM, etc...or
received DCN.
D
Transmitter received RTN after it
transmitted EOP, MPS, or EOM.
Defective SC PCB.
Modem is defective. (SC PCB)
Software problem occurred. (SC PCB)
Software problem occurred. (SC PCB)
Firmware update error.
GDI print error.
(Perform the operation again)
Wrong number is dialed and the START
button is pushed.
Telephone line is disconnected while
dialing.
SC PCB (Modem) or MJR PCB are
defective.
Receiver is defective. (It may only be
transmitting CED)
Your machine's ID Number is not
programmed.
Possible incompatibility or incorrect
Password.
Receiver working in non-CCITT mode
only. (Possible incompatibility)
not set at the transmitter.
Document to be transmitted is not
placed at the transmitter.
Receiver is defective. (Modem, MJR
PCB, etc.)
SC PCB or MJR PCB are defective.
Receiver disconnects line during first
NSS (or DCS) is transmitted.
Line quality is poor. (TCF is damaged
due to line noise)
Receiver is defective. (Modem, etc.)
SC PCB or MJR PCB are defective.
XMT, RCV password does not match.
Last 4 digits of TSI does not match with
the last 4 digits of ONE-TOUCH, ABBR
telephone number.
Receiver is defective. (No paper, paper
jamming, etc.)
Receiver ceased receiving because of
excessive error. (Line quality is poor)
SC PCB (Modem) or MJR PCB are
defective.
Receiver receives data with error. (Line
quality is poor)
Receiver is defective. (Modem, etc.)
SC PCB or MJR PCB are defective.
119
Cause
Hide quick links:
Advertisement
Table of Contents
