Panasonic UF-6300 Service Manual page 149
Hide thumbs
Also See for UF-6300:
- Operating instructions manual (166 pages) ,
- Operating instructions manual (100 pages) ,
- Operating instructions manual (166 pages)
Table of Contents
Advertisement
Error
Description of Problems
Code
65
Unit detected "Out of Paper".
81
No response from LP Controller.
82
Illegal response from LP Controller.
Note:
If an 021 series Error Code occurs, 021-25 (Thermistor Open) or 021-26 (Thermistor detected
temperature over 392°F (200°C), a pre-programmed recovery safety software is activated to protect the
unit and the service personnel during abnormal increase in temperature.
Once activated, this program is downloaded into the LPC PC Board's SRAM, disabling the Fuser Lamp
and preventing it from turning ON again.
In order to reset this circuit, please follow the procedure below.
1) Reset the LBP Fuser by using Service Mode 7-1-2 (Section 5.1.7.) and unplug & plug-in the power
cord.
2) Replace the Thermistor or Fuser Unit. If the problem persists.
3) Replace the SC PCB.
1. The Paper Cassette is empty.
2. Paper Detect Sensor defective.
1. SC PCB defective.
1. SC PCB defective.
149
Cause
Hide quick links:
Advertisement
Table of Contents
