Installing An Ac Or Dc Power Module; Removing A Chassis From The Equipment Rack - Cisco ASR 9001 Hardware Installation Manual
Hide thumbs
Also See for ASR 9001:
- Hardware installation manual (114 pages) ,
- Installation manual (24 pages) ,
- Overview and reference manual (170 pages)
Table of Contents
Advertisement
Removing a Chassis from the Equipment Rack
What to Do Next
Figure 62: Removing or Installing an AC or DC Power Module (AC power shown)
Installing an AC or DC Power Module
To install an AC or DC power module (see the above figure):
Procedure
Step 1
Slide the power module into the open bay until it mates with its backplane connector. Make sure that keying
lever locks with the chassis.
Step 2
Attach the power cabling to the power module.
Step 3
Verify that the OK (green) power indicator on the front of the power module comes ON. If the indicator does
not light up, see
Removing a Chassis from the Equipment Rack
Use this procedure to remove the chassis and its components from the equipment rack:
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
116
Troubleshooting the Power Subsystem, on page 87
Replacing Cisco ASR 9001 Router Components
section.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
