Changing The Security Context Url - Cisco Catalyst 6500 Series Configuration Manual
Catalyst 6500 series switch and
cisco 7600 series router firewall services
Hide thumbs
Also See for Catalyst 6500 Series:
- Software configuration manual (570 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
Chapter 5
Managing Security Contexts
To change between the system execution space and a context, or between contexts, see the following
commands:
•
•
Changing the Security Context URL
You cannot change the security context URL without reloading the configuration from the new URL.
When you reload the configuration, the new configuration merges with the one in running memory. A
merge adds any new commands from the new configuration to the running configuration. If the
configurations are the same, no changes occur. If commands conflict or if commands affect the running
of the context, then the effect of the merge depends on the command. You might get errors, or you might
have unexpected results. If the running configuration is blank (for example, if the server was unavailable
and the configuration was never downloaded), then the new configuration is used.
If you do not want to merge the configurations, you can clear the running configuration, which disrupts
any communications through the context, and then reload the configuration from the new URL.
To change the URL for a context, follow these steps:
If you do not want to merge the configuration, change to the context and clear its configuration by
Step 1
entering the following commands. If you want to perform a merge, skip to step 2.
FWSM# changeto context name
FWSM/ name # configuration terminal
FWSM/ name (config)# clear config all
If required, change to the system execution space by entering the following command:
Step 2
FWSM/ name (config)# changeto system
To enter the context configuration mode for the context you want to change, enter the following
Step 3
command:
FWSM(config)# context name
To enter the new URL, enter the following command:
Step 4
FWSM(config)# config-url new_url
The system immediately loads the context so that it is running.
OL-6392-01
To change to a context, enter the following command:
FWSM# changeto context name
The prompt changes to the following:
FWSM/ name #
To change to the system execution space, enter the following command:
FWSM/admin# changeto system
The prompt changes to the following:
FWSM#
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
Changing the Security Context URL
5-23
Advertisement
Table of Contents
Troubleshooting
