Table of Contents
Advertisement
Installing the Router
Connecting to the Alarm Port
Use a straight cable to connect to the alarm port. For details on the pinouts, see
94.
Connecting to the Management Ethernet Port
Use a straight or a cross over Ethernet cable to connect to the management Ethernet port. For details on the
pinouts, see
Dressing Router Cables
Ensure all Cisco router cables are properly dressed so as not to interfere with each other or other pieces of
equipment. Use local practices to ensure that the cables attached to your router are properly dressed.
To continue the installation, proceed to
Enabling Zero Touch Provisioning on the Router
Materials Required
• Phillips screwdriver
• Straightened paperclip or thin non-metallic pin no larger than 3/16 inches in diameter
OL-29732-01
Management Ethernet Port Pinouts, on page
Powering on the Router, on page
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
Dressing Router Cables
Alarm Port Pinouts, on page
94.
69.
67
Advertisement
Table of Contents
Troubleshooting
