Table of Contents
Advertisement
1/8 turn and tighten its locknut to the specified
torque.
1
1. Adjusting bolt
2. Locknut
Tightening torque:
Locknut (rear brake caliper):
16 Nm (1.6 m·kgf, 11 ft·lbf)
ECB00520
NOTICE
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that it does not turn
together with the locknut.
2
EWB02090
WARNING
Operating with improperly serviced or adjust-
ed brakes could cause the brakes to malfunc-
tion,
resulting
performance. This could increase the chance
of a collision or accident. After adjusting the
parking brake free play, block the rear of the
ATV off the ground and spin the rear wheels.
Check to make sure there is no brake drag. If
brake drag is noticed, perform the adjustment
again.
EBU24740
Brake light switches
The operation of the brake light switches must be
checked and, if necessary, adjusted at the inter-
vals specified in the periodic maintenance and lu-
brication chart.
The brake light switch for the brake pedal can be
adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
TIP
The brake light switch is properly adjusted when
the brake light comes on just before braking takes
8-38
in
reduced
braking
1
2
3
4
5
6
7
8
9
10
11
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
