Using The Mode Button; Web Browser Interface - Cisco Aironet 1130AG Hardware Installation Manual
Hide thumbs
Also See for Aironet 1130AG:
- Hardware installation manual (132 pages) ,
- Quick start manual (49 pages) ,
- Datasheet (13 pages)
Table of Contents
Advertisement
Chapter 6
Troubleshooting
Using the MODE Button
You can use the MODE button on the access point to reload the access point image file from an active
Trivial File Transfer Protocol (TFTP) server on your network or on a PC connected to the access point
Ethernet port.
If your access point experiences a firmware failure or a corrupt firmware image, indicated by the Status
Note
LED turning an amber color, you must reload the image from a connected TFTP server.
This process resets all configuration settings to factory defaults, including passwords, WEP keys, the
Note
access point IP address, and SSIDs.
Follow these steps to reload the access point image file:
The PC you intend to use must be configured with a static IP address in the same subnet as the access
Step 1
point.
Place a copy of the access point image file (such as c1130-k9w7-tar.123-2.JA.tar) into the TFTP server
Step 2
folder on your PC. For additional information, refer to the
"Obtaining the TFTP Server Software"
Rename the access point image file in the TFTP server folder to c1130-k9w7-tar.default.
Step 3
Activate the TFTP server.
Step 4
Step 5
If using in-line power, use a Category 5 (CAT5) Ethernet cable to connect your PC to the To Network
Ethernet connector on the power injector.
Open the access point cover (refer to the
Step 6
Step 7
Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the
access point.
Step 8
Press and hold the MODE button while you reconnect power to the access point.
Step 9
Hold the MODE button until the Radio LED turns a red color (approximately 20 to 30 seconds), and
release the MODE button.
Step 10
After the access point reboots, you must reconfigure the access point by using the Web interface, the
Telnet interface, or Cisco IOS commands.
Web Browser Interface
You can also use the Web browser interface to reload the access point image file. The Web browser
interface supports loading the image file using HTTP or TFTP interfaces.
Note
OL-6226-02
Your access point configuration is not changed when using the browser to reload the image file.
"Obtaining the Access Point Image File"
sections.
"Opening the Access Point Cover" section on page
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Reloading the Access Point Image
2-9).
6-17
and
- Quick Links:
- Ethernet Port
- Checking the Access Point Leds
Hide quick links:
Advertisement
Table of Contents
