Lift Lever; Hour Meter; Engine Temperature Gauge; Pto Switch - Toro 30868 Groundsmaster 4700-D Operator's Manual
Traction unit
Hide thumbs
Also See for 30868 Groundsmaster 4700-D:
- Service manual (298 pages) ,
- Installation instructions manual (20 pages) ,
- Operator's manual (92 pages)
Table of Contents
Advertisement
Figure 7
1. Throttle control
2. Lift lever
3. Hour meter
4. Engine temperature gauge
Lift Lever
The lever (Figure 7 ) raises and lowers the cutting units.
Hour Meter
The hour meter (Figure 7 ) shows the total hours that
the machine has been operated.
Engine Temperature Gauge
This gauge (Figure 7 ) indicates the engine coolant
temperature.
PTO Switch
The PTO switch (Figure 7 ) has two positions: On
(engage) and Off (disengage). Push the PTO switch
forward to the On position to start the implement or
cutting unit blades. Push the switch backward to the
Off position to stop implement operation.
Hi-Lo Speed Control
The switch (Figure 7 ) allows the speed range to
increase for transport of the machine. Cutting decks
will not operate in high range.
Power Point
The power point (Figure 7 ) is used to power optional
12 volt electrical accessories.
Fuel Gauge
The fuel gauge (Figure 8 ) indicates the level of fuel
in the tank.
5. PTO switch
6. Hi-Lo speed control
7. Power point
1. Fuel gauge
Cutting Unit Lift Latch (CE)
The cutting unit lift latch (Figure 9 ) locks the center
five cutting unit lift levers when the cutting units are in
the raised position.
1. Cutting unit lift latch
17
Figure 8
Figure 9
Hide quick links:
Advertisement
Table of Contents
