Setup; Installing The Seat, Seat Belt, And Manual Tube - Toro 30868 Groundsmaster 4700-D Operator's Manual
Traction unit
Hide thumbs
Also See for 30868 Groundsmaster 4700-D:
- Service manual (298 pages) ,
- Installation instructions manual (20 pages) ,
- Operator's manual (92 pages)
Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Seat Kit, Model 30398 (sold separately)
Seat Suspension Kit, Model 30395 (sold
separately)
Seat belt
1
Capscrew, 7/16-20 x 1 inch
Lockwasher, 7/16 inch
Manual Tube
R-clamp
2
No parts required
3
No parts required
Operator's Manual
Engine Operator's Manual
4
Parts Catalog
Operator Video
Pre-delivery Inspection Sheet
Note: Determine the left and right sides of the machine from the normal operating position.
Step
1
Installing the Seat, Seat
Belt, and Manual Tube
Parts needed for this step:
1
Seat Kit, Model 30398 (sold separately)
Seat Suspension Kit, Model 30395 (sold
1
separately)
1
Seat belt
2
Capscrew, 7/16-20 x 1 inch
2
Lockwasher, 7/16 inch
1
Manual Tube
2
R-clamp
Procedure
The machine is shipped without the seat assembly.
Deluxe Seat Kit, Model No. 30398, and Seat
Suspension Kit, Model No. 30395, must be purchased
and installed.
Description
13
Qty.
1
1
1
Install the seat, seat belt, and manual
2
tube.
2
1
2
–
Grease the machine.
Check the rear axle lubricant, hydraulic
–
uid, and engine oil levels
1
1
Read the manuals and watch the video
1
before operating the machine.
1
1
1. Mount the manual tube to the seat suspension with
the 2 R-clamps included in loose parts.
2. Install the seat belt to each side of the seat with a
bolt and lock washer, supplied in loose parts.
Important: Make sure that the seat switch
is connected to the seat switch connector on
the harness.
3. Slide the seat completely forward and backward to
ensure proper operation and that seat switch wires
and connectors are not pinched or do no contact
any moving parts.
Use
Hide quick links:
Advertisement
Table of Contents
