Table of Contents
Advertisement
6.
Connect the keyboard cable to pressure plate connector PJ10 on the system board. Con-
nect the LED cable to PJ11, the display cables to PJ12 and PJ13, and the display panel
shut-off switch to PJ15 on the system board (Figure 4-25).
7.
Replace the tape over the keyboard cable, LED cable, and display cables (Figure 4-28).
Figure 4-28 Applying the tape on the system board cables
8.
Connect the RTC battery cable to PJ2 on the system board. Connect the PS/2 mouse
cable to PJ19 on the system board (Figure 4-23).
9.
Place the RTC battery in the slot in front of the floppy disk drive bracket. Then route the
PS/2 mouse cable on top of the connector and on top of the RTC battery as you place the
mouse connector into the slot on the side of the computer. Make sure both cables are clear
4-30
- Quick Links:
- T3300Sl Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
