Configuring Pptp - Cisco RV180 Administrator's Manual
Hide thumbs
Also See for RV180:
- Administration manual (187 pages) ,
- Manual (14 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Configuring Networking
Configuring the WAN (Internet) Settings
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
Cisco RV180/RV180W Administration Guide
To see the details of available profiles, choose
Networking > WAN (Internet) > PPPoE Profiles. See
Profiles, page 30
for more information.
Enter MTU information. (See
Enter MAC Address information. (See
Click Save.
Configuring PPTP
If you have a Point-to-Point Tunneling Protocol (PPTP) connection to the Internet:
Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
From the Internet Connection Type drop-down menu, choose PPTP.
Enter this information:
User Name
Password
MPPE Encryption
Connection Type
Idle Time
Configuring MTU Settings, page
Configuring the MAC Address, page
Enter your username assigned to you by the ISP.
Enter your password assigned to you by the ISP.
If your ISP supports Microsoft Point-to-Point
Encryption (MPPE), check to enable MPPE
encryption.
Choose the connection type:
•
Keep connected—The Internet connection is
always on.
•
Idle Time—The Internet connection is on only
when traffic is present. If the connection is
idle—that is, no traffic is occurring within the
specified time frame—the connection is
closed. You might want to choose this option
if your ISP charges based on connection
time.
If you choose Idle Time as the connection type,
enter the number of minutes after which the
connection terminates. The valid range is 5–999.
2
Configuring PPPoE
29.)
29.)
27
Advertisement
Table of Contents
