Adding And Editing Authorized Aps; Configuring Wi-Fi Protected Setup - Cisco RV180 Administrator's Manual
Hide thumbs
Also See for RV180:
- Administration manual (187 pages) ,
- Manual (14 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Configuring the Wireless Network (Cisco RV180W)
Configuring Wi-Fi Protected Setup
STEP 1
STEP 2
STEP 3
STEP 4
Configuring Wi-Fi Protected Setup
NOTE
STEP 1
STEP 2
STEP 3
Cisco RV180/RV180W Administration Guide
Adding and Editing Authorized APs
To add or edit authorized APs:
Choose Wireless > Rogue AP > Authorized APs.
Click Add or check the box of an authorized AP and click Edit.
Select the following information:
•
MAC Address—The MAC, or hardware, address of the AP.
•
SSID—The broadcast name of the SSID.
•
Security—The type of security the AP uses.
•
Encryption—The type of encryption the AP uses.
•
Authentication—The type of authentication the AP uses.
•
Network Mode—The type of network on the AP.
•
Channel—The wireless channel of the AP.
Click Save.
You can configure Wi-Fi Protected Setup (WPS) on the Cisco RV180W to allow
WPS-enabled devices to more easily connect to the wireless network.
You must configure one AP with WPA/WPA2 to use WPS.
Choose Wireless > WPS.
In the VAP field, select the wireless network on which you want to enable WPS.
The network must use WPA, WPA2, or WPA+WPA2 security.
NOTE: You can enable WPS on only one of the four networks, or virtual access
points.
Under WPS Status, choose Enable to allow WPS configuration. By default, WPS is
disabled.
3
72
Advertisement
Table of Contents
