DIR-320NRU Multifunction Wireless Router Supporting
WiMAX, 3G GSM/CDMA with Built-in Switch
User Manual
Saving and Restoring Settings
!
Note that you should regularly save the changes of the router's settings to the non-
volatile memory.
The router's web-based interface displays the notification on unsaved changes at the top of the page.
You can save the router's settings via the top-page menu displayed when the mouse pointer is over
the System caption.
Click the Reboot line if you have already saved the router's settings.
Click the Save&Reboot line to save new settings and immediately reboot the router.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the router) to your PC. Also you can save the router's configuration to your PC via the Backup
button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware RESET button. The button is
located on the back panel of the router next to the power connector.
To restore the factory default settings, insert a small paperclip into the hole of the button (with the
router powered on), push, and hold for 10 seconds. Then remove the paperclip. All LEDs of the
router should turn off and then turn on again.
Wait for about 30 seconds. Now you can access the web-based interface of the router using the
default IP address, username and password.
If you fail to restore the factory defaults via the method described above, use the emergency reset
method.
Figure 21. The notification on unsaved changes.
Figure 22. The top-page menu.
Page 34 of 156
Installation and Connection