Cisco SPA232D Administration Manual page 89
Mobility enhanced phone adapter
Hide thumbs
Also See for SPA232D:
- Provisioning manual (213 pages) ,
- Quick start manual (17 pages) ,
- User manual (10 pages)
Table of Contents
Advertisement
Configuring the Voice Settings
Regional
Cisco SPA232D Administration Guide
Field
Ring Voltage
CWT Frequency
Synchronized Ring
Control Timer Values (sec)
Field
Hook Flash Timer
Min
Hook Flash Timer
Max
Callee On Hook
Delay
Reorder Delay
Call Back Expires
Call Back Retry
Intvl
Description
Ringing voltage. Choices are 60–90 (V)
Default setting: 85
Frequency script of the call waiting tone. All distinctive
CWTs are based on this tone.
Default setting: 440@-10
If this is set to yes, when the ATA is called, all lines ring at
the same time (similar to a regular PSTN line) After one line
answers, the others stop ringing.
Default setting: no
Description
Minimum on-hook time before off-hook qualifies as hook
flash. Less than this the on-hook event is ignored. Range:
0. 1 –0.4 seconds.
Default setting: 0. 1
Maximum on-hook time before off-hook qualifies as hook
flash. More than this the on-hook event is treated as on
hook (no hook-flash event) Range: 0.4–1.6 seconds.
Default setting: 0.9
Phone must be on-hook for at this time in sec. before the
ATA will tear down the current inbound call. It does not
apply to outbound calls. Range: 0–255 seconds.
Default setting: 0
Delay after far end hangs up before reorder tone is played.
0 = plays immediately, inf = never plays. Range: 0–255
seconds.
Default setting: 5.
Expiration time in seconds of a call back activation. Range:
0–65535 seconds.
Default setting: 1800
Call back retry interval in seconds. Range: 0–255
seconds.
Default setting: 30
4
88
- Quick Links:
- Connecting the Equipment
- Basic Setup
- Sip
Hide quick links:
Advertisement
Table of Contents
