Table of Contents
Advertisement
NFS Supra
3.4.2 Panel Enclosure Installation
The control panel enclosure is very simple to install providing the mounting
plate has been installed correctly as described in Section 3.4.1 Mounting
Plate Installation.
This procedure assumes that all field cables have been secured on the
mounting bracket with fire industry approved cable glands, using the appropriate
cable apertures (knockouts) and appropriately labeled by function in readiness for
termination within the panel.
Step 1:
• With the mounting plate installed on the wall in the desired location,
offer the two rebates located at the top of the panel enclosure to engage
the enclosure to the mounting plate.
• While performing this procedure, you will need to guide each of the
field cables through the aperture located at the back of the enclosure
until they are within the enclosure.
Step 2:
• Once the enclosure is aligned correctly with the mounting base, use
the 4 suitably-sized screws to fix it.
HLS-MN-025 v.04
www.honeywelllifesafety.es
www.hoeywelllifesafety.es
Installation
Installation and Operating Manual
Page 19
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
