Quick Reference; Attaching The Stand - Sharp AQUOS LC-80LE642U Operation Manual
Sharp aquos lc-80le642u liquid crystal television
Hide thumbs
Also See for AQUOS LC-80LE642U:
- Service manual (78 pages) ,
- Operation manual (56 pages) ,
- Setup manual (40 pages)
Table of Contents
Advertisement
QUICK REFERENCE
Before attaching the stand to the TV. build a work
2
table on which to rest the R/.
® To build the table, use the cushioning
materials
used in the packaging.
® Of the cushioning
materials used, TOP-C is also
used during sland unit assembly. Be sure to
assemble the stand unit before building the work
table.
TOP-L
TOP-R
\_
-TOP-C
3
The case is equipped with push-in tabs to
hold the cushioning
materials in place. Push
in the tabs (2 for each location) to secure the
cushioning materials in the case.
Push-in tabs
After you have built the work table, spread a
blanket or similar soft cloth over the table and
then lay the TV display down on the covered
table before attaching the stand to the IV.
Do not use a small table for this.
Refer to the operation manual for information on
attaching the stand.
Insert
each of the cushioning
materials
in the
respective
directions
shown
in the figure.
Insert TOP-L
and TOP-R
into the left and right
sides of the case respectively.
Insert TOP-C
to fR between
the lines on the other
side of the case.
TOP-L
CASE
LINE
® Before attaching (or detaching) the stand, unplug the AC cord.
® Before performing work spread cushioning over the base area to lay the IV ors. This will prevent it from
being damaged.
Be sure
to follow
the instructions,
incorrect
installation
of the stand
may
result
in the rv
falling
over,
1
2
Confirm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
_
Set the post for the stand unit onto the
polystyrene
foam.
_2_Attach the base to the post.
_
Insert and tighten the 8 screws into the 8
holes ors the bottom of the base.
Hold the stand unit securely with one hand,
and then tighten the screws.
3
4
Build the work tame.
Insert the stand into the openings on the rear of
the rv.
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tiring of the
TV set.
5
Insert and tighten the 4 screws into the 4 holes
on the rear of the stand unit.
Short screws
TOP-C
I o In the installation procedure, be careful not to catch your fingers between the
V .....
_
|
TV set and the floor.
/i
'/
/
o Do not remove the stand from the 13! unless using an optional wall
I;
,'I
|
mount bracket to mount it.
['
X,,_,!_J' /
|
o After attaching
the stand to the TV, do not hold the stand when you
_--_--_'___
|
put up, set up, move or lay down the TV.
//_
J
_-6
- Quick Links:
- Remote Control Unit
Hide quick links:
Advertisement
Table of Contents
