Adjusting The Upper Thread Scissors Gradual Opening Timing - Brother HE-800A Service Manual
Electronic lockstitch button holer
Hide thumbs
Also See for HE-800A:
- Manual del instrucción (122 pages) ,
- User manual (118 pages) ,
- Instruction manual (118 pages)
Table of Contents
Advertisement
4. ADJUSTMENT
4-14-7. Adjusting the upper thread scissors gradual opening timing
4334Q
Start touching at 1.5 - 2.5mm
Approx. 0.5mm
4335Q
1. Turn on the power and set the sewing machine to the home position. Then press the RESET key to lower the
work clamp.
2. Loosen the two bolts (3), and then adjust so that the distance a between ridge line A on the opening cam (1)
and the upper thread scissors (2) is 0.5 mm, and so that ridge line A on the opening cam is parallel to the feed
direction.
3. Loosen the two screws (4), and then adjust so that the distance b between the rising section B of the upper
thread scissors (2) and the tip of the opening cam (1) is approximately 0.5 mm when the upper thread scissors
(2) are closed.
* If you would like the scissors to start opening earlier, make the distance smaller. However, if you make the
distance smaller, check that the rising section B of the upper thread scissors (2) does not touch the opening
cam (1) and prevent the upper thread scissors (2) from opening when the work clamp is lowered.
4. Apply grease to the inclined face C of the opening cam (1).
5. Check that the upper thread scissors (2) gradually start opening after the material has been fed by 1.5 - 2.5
mm.
94
Approx. 0.5mm
HE-800A
4336Q
Hide quick links:
Advertisement
Table of Contents
