The installation steps are described in the enclosed "Installation Diagram". Leave these instructions with the appliance for the consumer/user. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information. CVA 6805...
Caring for the environment Disposal of packing material Disposal of an old appliance The cardboard box and packing Old appliances may contain materials materials protect the appliance during that can be recycled. Please contact shipping. They have been designed to your local recycling authority about the be biodegradable and recyclable.
Page 3
Turn off the water supply before connecting the coffee machine to the plumbing. Parts must only be replaced with original Miele spare parts, available – All units and systems used to deliver from Miele. the water to the coffee system must conform with the requirements of the respective country.
Page 4
Plumbing Installing the stainless steel Connection to the water tubing in the unit supply Make sure the stainless steel tube is Disconnect the machine from the not kinked or damaged. Do not trim electrical supply before connecting stainless steel tube. it to the water supply.
Lead free certificate This product is tested and certified by the WQA against ORD0902 for California "lead free" compliance. Miele & Cie KG Carl-Miele-Straße 29 D-3332 Gütersloh...
If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or contact Miele’s Technical Service Department. See back page for contact information.
Installation Installation and combination options The system is designed to be built into cabinetry.
Page 8
Installation It is also possible to combine it with other built-in Miele appliances. If the coffee system is to be built in above another appliance, there must be a full-width, closed shelf between them (exception: installation with a built-in warming drawer).
Page 9
Otherwise condensation can form, ^ If there is no sealing strip around the causing damage to the coffee system installation recess, stick the Miele or the surrounding cabinets. sealing strip onto the unit from the back before putting it into the recess.
Page 10
Installation Tip: A place to set down the coffee The coffee machine is delivered with machine at the level of the installation four M5 Allen head screws that you can recess is helpful. This makes it easier use to align and fasten the unit in the for you to install the unit's electrical and installation recess.
Page 11
Installation Adjusting the door hinges If the door cannot be opened or closed easily after installation, you will have to align the door (TX 20): ^ To adjust the door flush with the front of the cabinet, turn the screw a. ^ To adjust the door horizontally and vertically, turn the screw b.
'virtual link' between your following requirements appliance and our monitoring center. If – A wireless router that supports an a fault occurs, Miele's client service IEEE 802.11b/g protocol center will be notified and contact you, ® or another trusted individual identified –...
Systems Incorporated, Adobe Macromedia Software LLC. Adobe and Flash are registered trademarks of Adobe Systems Incorporated. The proprietary rights of Miele and other relevant software suppliers (e.g. Adobe) must be respected. Miele and its suppliers reserve all rights to the software components.
Page 17
Technical Service. U.S.A. Canada Miele, Inc. Importer Miele Limited National Headquarters 9 Independence Way Headquarters and Miele Centre Princeton, NJ 08540 161 Four Valley Drive 800-843-7231 Phone: Vaughan, ON L4K 4V8 609-419-9898 www.miele.ca 609-419-4298...
Page 18
CVA 6805 en - US, CA M.-Nr. 09 741 680 / 02...