Table of Contents
Advertisement
Tips for Improved Performance,
continued
DHCT does not work
• Verify that the DHCT is properly plugged into an
electrical outlet that is not controlled by a wall switch.
• Verify that all cables are properly connected.
• If the electrical outlet is controlled by a wall switch,
make sure the switch is in the ON position.
Channel banner displays ??? (question marks)
instead of the channel number
• Press the INFO key on the remote control. You may
have pressed the Power key before all of the data
for the IPG was received by the DHCT.
TV screen displays a message indicating that the
DHCT is automatically updating its software
• Wait for the time to display on the LED before
continuing with your installation process.
30
Notices
Disclaimer
Cisco Systems, Inc. assumes no responsibility for
errors or omissions that may appear in this guide. Cisco
reserves the right to change this guide at any time
without notice.
Software and Firmware Use
The software described in this document is protected
by copyright law and furnished to you under a license
agreement. You may only use or copy this software in
accordance with the terms of your license agreement.
The fi rmware in this equipment is protected by copyright
law. You may only use the fi rmware in the equipment in
which it is provided. Any reproduction or distribution of
this fi rmware, or any portion of it, without our express
written consent is prohibited.
Advertisement
Table of Contents
