Installing A Din Rail - Cisco 800 Series Hardware Installation Manual
800 series integrated services router
Hide thumbs
Also See for 800 Series:
- Design manual (50 pages) ,
- Release notes (36 pages) ,
- Configuring (32 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Router
Figure 2-22
Note
For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and
washers must be size number 10.
Route the cables so that they do not put a strain on the connectors or mounting hardware.
Step 4
To comply with IP 41, cables should be routed down relative to the router to prevent water from
travelling on the cables.
Installing a DIN Rail
You can use either the 7.5-mm or the 15-mm thick DIN rail for the Cisco 819 ISR. Secure the DIN rail
to the mounting surface approximately every 7.8 inches (200 mm) and use end-anchors appropriately.
Note
DIN rail mounting is not supported on Cisco 819HGW and Cisco 819HWD ISRs.
Installing the Router to the Wall
Cisco Integrated Services Router Hardware Installation Guide
Installing the Cisco 810 ISR
2-27
- Quick Links:
- Hardware Features
Hide quick links:
Advertisement
Chapters
Table of Contents
