Table of Contents
Advertisement
Installing the Router
Figure 2-5
For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and
Note
washers must be size number 10.
Route the cables so that they do not put a strain on the connectors or mounting hardware. To comply with
Step 4
IP 41, cables should be routed down relative to the router to prevent water from travelling on the cables.
Installing a DIN Rail
You can use either the 7.5-mm or the 15-mm thick DIN rail for the Cisco 819 ISR. Secure the DIN rail
to the mounting surface approximately every 7.8 inches (200 mm) and use end-anchors appropriately.
DIN rail mounting is not supported on Cisco 819HGW and Cisco 819HWD ISRs.
Note
Cisco 819 Integrated Services Router Hardware Installation Guide
2-10
Installing the Router to the Wall
Chapter 2
Installing the Router
OL-23125-02
Hide quick links:
Advertisement
Table of Contents
