Children of less than 3 years should be kept away unless • continuously supervised. General Safety The appliance and its accessible parts become hot during use. • Do not touch the heating elements. Do not operate the appliance by means of an external timer or • separate remote-control system. www.zanussi.com...
• Seal the cut surfaces with a sealant to Only a qualified person must install prevent moisture to cause swelling. this appliance. • Protect the bottom of the appliance from steam and moisture. • Remove all the packaging. • Do not install or use a damaged appliance. www.zanussi.com...
• When you place food into hot oil, it may • If the mains socket is loose, do not connect splash. the mains plug. www.zanussi.com...
Page 5
• Disconnect the appliance from the mains • Use only the accessories supplied with the supply. appliance. • Cut off the mains cable and discard it. • Do not install a flame diffuser on the burner. • Flat the external gas pipes. www.zanussi.com...
Symbol Description Symbol Description ignition position / maximum no gas supply / off position gas supply minimum gas supply Daily use WARNING! Refer to Safety chapters. Burner overview A) Burner cap B) Burner crown C) Ignition candle D) Thermocouple www.zanussi.com...
WARNING! lower gas consumption. Do not put unstable or damaged CAUTION! pots on the burners to prevent from Liquids spilt during cooking can spill and injury. cause the glass to break. www.zanussi.com...
Keep Be very careful when you these components well clean to prevent difficult replace the pan supports to lighting and check that the burner crown holes prevent the hob top from are not obstructed. damage. www.zanussi.com...
Service Centre and conditions of yourself, contact your dealer or an Authorised guarantee are in the guarantee booklet. Service Centre. Give the data from the rating plate. Make sure, you operated the hob correctly. If not the servicing by a service www.zanussi.com...
For appliances installed in the Republic of same room, B.S. 5440 Part 2 Current Edition, Ireland please refer to NSAI- Domestic Gas should be consulted to determine the requisite Installation I.S. 813 Current Editions and the air vent requirements. ETCI Rules for Electrical Installations. www.zanussi.com...
A) End of shaft with nut different from the necessary pressure, you must B) Washer fit an applicable pressure adjuster on the gas C) Elbow supply pipe. Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. www.zanussi.com...
D) Cord clamp qualified electrician (e.g. your local Electricity E) Blue Board, or a contractor who is on the roll of the The wires in the cord are coloured as follows: National Inspection Council for Electrical Installation Contracting [NICEIC]). www.zanussi.com...
'L'. It must always be connected to the network phase. There must be no cut or stray strands of wire present. The cord clamp must be correctly attached to the outer sheath. www.zanussi.com...
G30 (3+) 28-30 mbar = 763 g/h G31 (3+) 37 mbar = 750 g/h Electric supply: 230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: www.zanussi.com...
Page 15
Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. www.zanussi.com...