Table of Contents
Advertisement
Configuring Cisco CallManager
Table 4-1
System Setup Checklist
Task
Cisco CallManager Configuration
Add the DPA 7630/7610 to the
Cisco CallManager database.
Verify that the voice mail hunt group is set up
properly.
Configure the ports from the DPA 7630/7610
as Cisco IP Phones in Cisco CallManager.
Verify that the options for enabling and
disabling MWI on the Cisco IP Phones are
configured in Cisco CallManager.
Octel Configuration
Set dialing sequence for message waiting
indicator.
Determine incoming call method.
Assign lines to handle incoming calls,
outgoing calls, and MWI commands.
Configuring Cisco CallManager
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
4-2
information from both the Cisco CallManager and Octel systems. Refer to
Table 4-1
for an overview of the tasks and information you need from them to
configure the DPA 7630/7610.
The DPA requires minor changes to Cisco CallManager because when you add
the DPA 7630/7610 to the IP network, Cisco CallManager recognizes the ports as
Cisco IP Phones. Therefore, you need to add these ports to the Cisco CallManager
database. Additionally, because of the close interaction of the DPA 7630/7610
with the voice mail system, you must ensure that some key voice mail settings on
the Cisco CallManager system are properly configured.
Chapter 4
Preparing the Cisco CallManager and Octel Systems
For More Information
See
"Adding the DPA 7630/7610 to
Cisco CallManager" section on page
See
"Setting Up the Voice Mail Hunt Group"
section on page 4-5
See
"Configuring the DPA Ports and Phones"
section on page
4-10.
See
"Configuring the Message Waiting Light"
section on page
4-13.
See the
"Setting Dialing Sequence for Message
Waiting Indicator" section on page
See the
"Determining Incoming Call Mode"
section on page
4-15.
See the
"Assigning Incoming, Outgoing, and
MWI Lines" section on page
4-3.
4-15.
4-16.
78-11069-03
Advertisement
Chapters
Table of Contents
Troubleshooting
