Entering The Initial Configuration Information; Ip Settings; Completing The Setup Program - Cisco Catalyst 2950 Hardware Installation Manual
Desktop switch
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Entering the Initial Configuration Information
Entering the Initial Configuration Information
IP Settings
Completing the Setup Program
Step 1
Catalyst 2950 Desktop Switch Hardware Installation Guide
1-6
To set up the switch, you need to complete the setup program, which runs
automatically after the switch is powered up. You must assign an IP address and
other configuration information necessary for the switch to communicate with the
local routers and the Internet. This information is also required if you plan to use
the Cluster Management Suite (CMS) to configure and manage the switch.
You will need this information from your network administrator before you
complete the setup program:
•
Switch IP address
•
Subnet mask (IP netmask)
Default gateway (router)
•
•
Enable secret password
Enable password
•
Telnet password
•
Follow these steps to complete the setup program and to create an initial
configuration for the switch:
Enter Yes at these two prompts.
Would you like to enter the initial configuration dialog? [yes/no]:
yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Chapter 1
Quick Installation
78-11157-05
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
