Table of Contents
Advertisement
Test Mode
Type of Mode
PRINT TEST
Service Mode
PATTERN
Note:
The numbers in the boxes (XXX) indicate the keys to be input for the various test modes.
6.3.1.
DTMF SINGLE TONE TRANSMIT SELECTION
Note:
After performing this check, do not forget to turn the setting off.
otherwise, dialing in DTMF signal will not work.
6.3.2.
BUTTON CODE TABLE
Code
Operation after code
input
"8" "5" "2"
1. Press "852" then the SET key in the service mode.
2. As "PATNO =" is displayed on the LCD, enter the test pattern No. and press
START
the SET key.
3. When "No. = "is displayed on the LCD, enter the printing number and press the
SET key. (Press "00" for the infinite printing.)
4. "MODE" is displayed on the LCD. Press "0" to start printing or press "1" to go
to the next screen.
5. When "1" is pressed at MODE, "INTVL = "is displayed on the LCD. Enter the
printing interval (00~99 sec).
6. The printing repeats the designated number of times at the programmed
printing intervals.
75
Function
KX-FLB758RU
Advertisement
Table of Contents
Troubleshooting
