Overview of Configuring and Installing Cisco Unified IP Phones
Overview of Configuring and Installing Cisco Unified IP Phones
When deploying a new IP telephony system, system administrators and network administrators must
complete several initial configuration tasks to prepare the network for IP telephony service. For
information and a checklist for setting up and configuring a Cisco IP telephony network, go to the
System Configuration Overview
After you have set up the IP telephony system and configured system-wide features in Cisco Unified
CM, you can add IP phones to the system.
The following topics provide an overview of procedures for adding Cisco Unified IP Phones to
your network:
•
•
Configuring Cisco Unified IP Phones in Cisco Unified CM
To add phones to the Cisco Unified CM database, you can use:
•
•
•
•
For more information about these choices, see the
section on page
For general information about configuring phones in Cisco Unified CM, refer to the
following documentation:
•
•
•
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP)
1-22
Configuring Cisco Unified IP Phones in Cisco Unified CM, page 1-22
Installing Cisco Unified IP Phones, page 1-26
Auto-registration
Cisco Unified CM Administration
Bulk Administration Tool (BAT)
BAT and the Tool for Auto-Registered Phones Support (TAPS)
2-8.
Cisco Unified IP
Phones, Cisco Unified Communications Manager System Guide
Cisco Unified IP Phone
Configuration, Cisco Unified Communications Manager Administration
Guide
Autoregistration
Configuration, Cisco Unified Communications Manager Administration Guide
Chapter 1
chapter in Cisco Unified Communications Manager System Guide.
"Adding Phones to the Cisco Unified CM Database"
An Overview of the Cisco Unified IP Phone
OL-20851-01