Page 2
For further information, please contact your local or regional authorities. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of www.beko.com hazardous substances. This product was manufactured using the latest technology in environmentally friendly conditions.
Refrigerator ........13 the problems Connection of Water Hose to the Bottle 15 Connection of the Water Pipe to the Cold 8 Beko Customer Care Water Mains Line ......15 Prior to first use of Ice/Water Dispenser 17 4 Preparation...
Important Safety Warnings Please review the following informa- • Do not touch frozen food by hand; tion. Failure to observe this information they may stick to your hand. may cause injuries or material damage. • Unplug your refrigerator before clean- Otherwise, all warranty and reliability ing or defrosting.
Page 6
• Do not use mechanical devices • Avoid causing damage on power or other means to accelerate the cable when transporting the refrigera- defrosting process, other than those tor. Bending cable may cause fire. recommended by the manufacturer. Never place heavy objects on power cable.
HCA Warning • If not to be used for a long time, refrigerator should be unplugged. • If your product's cooling system The plug’s tip should be regularly contains R600a: cleaned; otherwise, it may cause fire. This gas is flammable. Therefore, pay •...
Installation Please remember that the 2. Insert the 2 plastic wedges onto manufacturer shall not be held liable if the rear ventilation as illustrated in the information given in the instruction the following figure. Plastic wedges manual is not observed. will provide the required distance between your refrigerator and the wall in order to allow the air circulation.
Electric connection Before disposing of your refrigerator, cut off the electric plug and, if there Connect your product to a grounded are any locks on the door, make them socket which is being protected by a inoperable in order to protect children fuse with the appropriate capacity.
Floor balance adjustment 2. Loosen the three screws of the hinges of the lower door, which you If your refrigerator is unbalanced; wish to escalate, with the help of a You can balance your refrigerator by screwdriver as shown in the figure turning the front feets of it as illustrated below.
Page 11
• If the freezer compartment door is After bringing the doors to the same lower than the fridge compartment level by elevating the front part with door, bring them to the same level by the aid of the elevation screws, doors turning the turning the elevation screw of the refrigerator shall close properly.
Adjusting the gap between Switch off the refrigerator power before the upper door removing hinge covers You can adjust the gap between the fridge compartment doors as illustrated in the figures. Using a screwdriver, remove the screw of upper hinge cover of the door you want to adjust.
Installing Water Filter (in some models) Installation Requirements Two different water sources may be connected to the refrigerator for water supply: the mains cold water supply and water in a bottle. A pump should be used for bottle water usage. Check that the parts stated below are supplied with your appliance.
Connection of the Water Pipe to the Refrigerator 1. After installing the union onto the water pipe, insert the water pipe to Water connection to the the refrigerator inlet valve by pressing refrigerator downwards firmly. Please follow the instructions 2. Fix union as seen in the opposite below.
Page 15
1. Press ice cancel button on the Note: It is normal that a few drops of display. (Figure 1) water drip after the cover has been taken out. 2. Remove the filter cover in the fridge compartment by pulling it forward. 4.
Connection of Water Hose to Note: You may refer to the user the Bottle manual of the pump while making the water connection. (in some models) To connect water to the refrigerator Connection of the Water from a bottle, a pump is needed. Pipe to the Cold Water Mains Line (in some models)
Page 17
this valve is not present or in case you are not sure, consult a qualified plumber. 1. Separate the union from the tap adaptor. (Figure A) 2. Install the tap adaptor to 1/2” valve fitting as shown in the figure. (Figure 3.
Prior to first use of Ice/Water The first 10 glasses of water should Dispenser not be consumed. 12 hours must pass to obtain ice Water mains pressure must not be from the Ice Dispenser for the first below 1 bar. time.
Preparation Your refrigerator should be installed at least 30 cm away from heat sources such as hobs, ovens, central heater and stoves and at least 5 cm away from electrical ovens and should not be located under direct sunlight. The ambient temperature of the room where you install your refrigerator should at least be 10°C.
Using your refrigerator 2 °C -24 °C 4 °C -21 °C 6 °C -18 °C 8 °C -15 °C 16. Fridge temperature setting indicator 1. Fridge Set button 17. High temperature/error warning indicator 2. Vacation mode button 18. Fridge door open indicator 3.
Freezer Fridge Explanations Compartment Compartment Adjustment Adjustment -15°C 4°C This is the normal recommended setting. -18,-21 or -24°C 4°C These settings are recommended when the ambient temperature exceeds 30°C. Fresh Freeze 4°C Use this when you wish to freeze your food or make ice in a short time.
Auto Eco Button (Special If you want to freeze large amounts Economy function) of fresh food, press the Fresh Freeze button 14 hours before putting the When “Auto Eco” button is pressed, food into the freezer compartment. Auto Economy Function will be Quick Cool Function activated.
Ice/Water Dispenser It is normal to get crushed ice from the dispenser in a longer time than in With its three different functions, the getting the ice cubes and also flowing dispenser efficiently meets your cold of some crushed ice before the ice water, cube ice and crushed ice needs cubes drop if crushed ice option had without having to open the door of...
Ice Off Changing the illumination To stop ice formation, Ice Off To change the lamp used for button is pressed. When Ice Off is illumination of your refrigerator, please selected, no water will be taken into call your Authorized Service. the Icematic.
Using the water spring Sliding Body Shelves Sliding body shelves can be pulled by slightly lifting up from the front and moved back and forth. They come to a stop point when pulled towards front to allow you reach the foods placed at the back of the shelf;...
Blue light Crisper humidity control sliders Foodstuff stored in the crispers that are enlightened with a blue light Crisper of your refrigerator is continue their photosynthesis by designed especially fresh to keep your means of the wavelength effect of blue vegetables freshly without loosing their light and thus, preserve their freshness humidity.
Recommendations for preservation of frozen food • Prepacked commercially frozen food should be stored in accordance with the frozen food manufacturer's instructions for a frozen food storage compartment. • To ensure that the high quality achieved by the frozen food manufacturer and the food retailer is maintained, the following should be remembered:...
Maintenance and cleaning Protection of plastic A Never use gasoline, benzene or surfaces similar substances for cleaning purposes. C Do not put the liquid oils or oil-cooked B We recommend that you unplug the meals in your refrigerator in unsealed appliance before cleaning.
Icebox and Water Dispenser Follow the procedure and warnings below to clean the icebox: Remove the Icebox by lifting first and then pulling towards yourself as shown in the diagram. Empty the ice in the Icebox if any. To take out the stuck ice, use objects that are not sharp to avoid any damage on the Icebox.
Recommended solutions for the problems Please review this list before calling the service. It might save you time and money. This list includes frequent complaints that are not arising from defective workmanship or material usage. Some of the features described here may not exist in your product.
Page 31
• The ambient room temperature may be high.This is quite normal. • The refrigerator may have just been switched on. Allow sufficient cooling time. • Large amounts of hot food might have been put in the refrigerator recently. Hot food causes longer running of the refrigerator until they reach the safe storage temperature.
Page 32
• This noise is coming from the solenoid valve of the refrigerator. Solenoid valve functions for the purpose of ensuring coolant passage through the compartment which can be adjusted to cooling or freezing temperatures, and performing cooling functions. This is normal and is not fault cause. The operation noise increases when the refrigerator is running.
You are familiar with its normal mode of operation You have read the ‘Recommended solutions for the problems’ If after checking the points above, the problem still exists, please call our Beko Customer Care hotline as listed below:- If calling from Australia..