Manual Setup - IBM ThinkVision L170 User Manual
Ibm lcd monitor user's guide
Hide thumbs
Also See for ThinkVision L170:
- Service manual (54 pages) ,
- User manual (32 pages) ,
- Service manual (28 pages)
Table of Contents
Advertisement
L170_E.fm Page 14 Friday, February 21, 2003 4:32 AM
Manual Setup
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off while
you are waiting for it to warm up.
14
Normally, you can complete the setup procedure using
if your screen image is still distorted after you perform
Installation CD does not run on your system, perform
1.
Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2.
Display the image you most frequently use on the screen.
3.
Press the OSD Enter button
the initial OSD menu.
4.
Use the
or
the OSD Enter button
5.
Use the
or
Once Clock becomes highlighted, press the OSD Enter button
6.
Use the
or
possible) for noise in the video signal then press the Exit (
save the changes.
7.
Use the
or
8.
Use the
or
To save, press the
9.
When finished, press the Exit (
OSD.
You have completed monitor setup.
at the bottom of the monitor to display
button to select the Image Setup icon
to access.
button to select Clock.
button to manually adjust to correct (as much as
button to select Phase and press the
buttons again to tune the image to your liking.
button two times.
) button two times to exit from the
; however,
A
S
UTO
ETUP
or the
A
S
UTO
ETUP
.
M
S
ANUAL
ETUP
and press
.
) button to
button.
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
