Engine; Flushing Device; Install Top Cowling - Yamaha F50 Owner's Manual
Hide thumbs
Also See for F50:
- Owner's manual (106 pages) ,
- Rigging manual (497 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
1
1. Oil dipstick
3.
Insert the oil dipstick completely and re-
move it again.
4.
Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil
level is not at the proper level or if it ap-
pears milky or dirty.
1
3
1. Lower mark
2. Oil dipstick
3. Upper mark
EMU27153
Engine
Check the engine and engine mounting.
Look for loose or damaged fasteners.
Check the propeller for damage.
Check for engine oil leaks.
EMU36493
Flushing device
Check that the flushing device's garden hose
ZMU05089
2
ZMU05091
connector is securely screwed on to the fit-
ting on the bottom cowling. NOTICE: If the
garden hose connector is not properly
connected, cooling water can leak out
and the engine can overheat during oper-
ation.
[ECM01801]
1
2
1. Fitting
2. Flushing device
EMU36955
Install top cowling
1.
Be sure that the cowling lock lever is re-
leased.
2.
Be sure that the rubber seal is seated all
the way around the top cowling.
3.
Place the top cowling on the bottom
cowling.
4.
Check to be sure the rubber seal is seat-
ed correctly between the top cowling
and the bottom cowling.
5.
Move the cowling lock lever to lock the
top cowling as shown. NOTICE: If the
top cowling is not installed correctly,
water spray under the top cowling
can damage the engine, or the top
cowling can blow off at high speeds.
[ECM01991]
Operation
ZMU07080
57
Advertisement
Table of Contents
