Cisco Aironet Installation And Configuration Manual page 144
Wireless lan client adapters for windows
Hide thumbs
Also See for Aironet:
- Installation and configuration manual (92 pages) ,
- Quick start manual (12 pages) ,
- Getting started manual (38 pages)
Table of Contents
Advertisement
Viewing Statistics for Your Client Adapter
Table 7-4
Statistic
AP Mismatches
Data Rate Mismatches
Authentication Rejects
Authentication T/O
Association Rejects
Association T/O
Packets Aged
Packets MIC OK
Packets No MIC
Packets Incorrect MIC
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
7-14
Client Adapter Statistics (continued)
Description
The number of times the client adapter tried to associate to an
access point but was unable to because the access point was not
the adapter's specified access point.
Note
The number of times the client adapter tried to associate to an
access point but was unable to because the adapter's data rate was
not supported by the access point.
Note
The number of times the client adapter tried to authenticate to an
access point but was rejected.
The number of times the client adapter tried to authenticate to an
access point but was unable to because the access point did not
respond fast enough (timed out).
The number of times the client adapter tried to associate to an
access point but was rejected.
The number of times the client adapter tried to associate to an
access point but was unable to because the access point did not
respond fast enough (timed out).
The number of packets received successfully but discarded by the
client adapter because either all fragments were not received
within 10 seconds or the host did not read the packet from the
adapter within 10 seconds.
The number of packets that were received successfully with a
valid message integrity check (MIC).
Note
The number of packets that were discarded due to no MIC being
found.
Note
The number of packets that were discarded due to an incorrect
MIC value.
Note
Refer to the Specified Access Point 1- 4 parameter in
Table 5-4
for information on specifying access points.
Refer to the Data Rate parameter in
information on supported data rates.
This field is not displayed if the client adapter's driver
does not support MIC functionality or MIC is not enabled
on the access point.
This field is not displayed if the client adapter's driver
does not support MIC functionality or MIC is not enabled
on the access point.
This field is not displayed if the client adapter's driver
does not support MIC functionality or MIC is not enabled
on the access point.
Chapter 7
Performing Diagnostics
Table 5-3
for
OL-1394-04
Advertisement
Table of Contents
Troubleshooting
