Cisco RV180 Administration Manual page 173
Vpn router/wireless-n multifunction router
Hide thumbs
Also See for RV180:
- Administrator's manual (183 pages) ,
- Manual (14 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Viewing the Cisco RV180/RV180W Status
Viewing the System Summary
Cisco RV180/RV180W Administration Guide
WAN (Internet) Information (IPv4)
MAC Address
Connection Time
Connection Type
Connection State
DHCP Server
Lease Obtained
Lease Duration
IP Address
Subnet Mask
Gateway
Primary DNS Server
Secondary DNS Server
NAT (IPv4 Only Mode)
Release/Renew
Connect/Disconnect
The MAC address of the WAN port.
The time duration for which the connection is up.
Indicates if the WAN IPv4 address is obtained
dynamically through a DHCP server, assigned
statically by the user, or obtained through a PPPoE/
PPTP/L2TP ISP connection.
Indicates if the WAN port is connected to the
Internet service provider.
The IP address of the DHCP server to which the
WAN port is connected.
The the time at which lease is obtained from the
DHCP server.
The duration for which the lease remains active.
The WAN Address of the device.
The subnet mask of the WAN port.
The gateway IP address of the WAN port.
The IP address of the primary DNS server.
The IP address of the secondary DNS server.
Indicates if the router is in NAT mode (enabled) or
routing mode (disabled).
Visible if automatic configuration - DHCP is
connected as the Internet connection type. Click
Release to release the current IP address that was
assigned to your WAN port. Click Renew to obtain
a new IP address for your WAN port.
Visible if an Internet connection type other than
automatic (DHCP) has been chosen. Click Connect
to connect to the selected server. Click Disconnect
to disconnect from the server to which you are
connected.
8
164
- Quick Links:
- Product Overview
- Lan Ethernet Interfaces
Hide quick links:
Advertisement
Table of Contents
