Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZBB5284
Summary of Contents for Zanussi ZBB5284
- Page 1 User manual Fridge-Freezer ZBB5284...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4... - Page 3 or damaged power plug may overheat and cause a Care and cleaning fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug of connect the mains plug from the mains socket. the appliance.
-
Page 4: First Use
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials. -
Page 5: Helpful Hints And Tips
Place the fresh food to be frozen on the top compartment. Important! Do not use metallic instruments to remove the trays from the freezer. Storage of frozen food When first starting-up or after a period out of use, before Movable shelves putting the products in the compartment let the appliance run at least 2 hours on the higher settings. -
Page 6: Care And Cleaning
Butter and cheese: these should be placed in special air- • lean foods store better and longer than fatty ones; salt tight containers or wrapped in aluminium foil or polythene reduces the storage life of food; bags to exclude as much air as possible. •... -
Page 7: What To Do If
It is important to periodically clean the defrost water drain In order to speed up the defrosting process, place a hole in the middle of the refrigerator compartment channel pot of warm water in the freezer compartment. In ad- to prevent the water overflowing and dripping onto the dition, remove pieces of ice that break away before de- food inside. - Page 8 Problem Possible cause Solution The appliance does not operate. The appliance is switched off. Switch on the appliance. The lamp does not operate. The mains plug is not connected to the Connect the mains plug to the mains mains socket correctly. socket correctly.
-
Page 9: Technical Data
Replacing the lamp power and specifically designed for household appli- ances (the maximum power is shown on the lamp Caution! Disconnect the plug from the mains cover). socket. 4. Install the lamp cover. 1. Remove the screw 5. Tighten the screw to the lamp cover. from the lamp cov- 6. - Page 10 1. Connect the wire coloured green and yellow to the Warning! This appliance must be earthed. terminal marked either with the letter “E“ or by the The manufacturer declines any liability should these earth symbol or coloured green and yellow. safety measures not be observed.
- Page 11 Ventilation requirements Installing the appliance Caution! Make sure that the mains cable can move The airflow behind the ap- freely. pliance must be sufficient. min. 50 mm 200 cm Do the following steps: min. 200 cm 44mm If necessary cut the adhe- Install the appliance in the Adjust the appliance in the Attach the appliance to the...
- Page 12 Remove the correct part Attach the covers (C, D) to Connect the appliance lat- Disconnect the parts (Ha), from the hinge cover (E). the lugs and the hinge erally to the kitchen furni- (Hb), (Hc) and (Hd). Make sure to remove the holes.
-
Page 13: Environmental Concerns
Place the small square on Press the part (Hd) on the the guide again and fix it part (Hb). with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Do a final check to make sure that: Important! If the ambient temperature is low (for example, in the Winter), the size of the gasket decreases. - Page 16 www.zanussi.com/shop...