Make sure that the power plug is not squashed or prevent it from becoming a death trap for a child. damaged by the back of the appliance. A squash- General safety ed or damaged power plug may overheat and cause a fire. Warning! www.zanussi.com...
Page 3
• Do not use sharp objects to remove frost from the ap- er. The materials used on this appliance marked by the pliance. Use a plastic scraper. symbol are recyclable. www.zanussi.com...
This appliance is equipped with one or more trays for the drawers and baskets from appliance and place food on production of ice-cubes. Fill these trays with water, then cooling shelves to obtain the best performance. put them in the freezer compartment. www.zanussi.com...
• do not allow fresh, unfrozen food to touch food which Cooked foods, cold dishes, etc..: these should be covered is already frozen, thus avoiding a rise in temperature of and may be placed on any shelf. the latter; www.zanussi.com...
After cleaning, reconnect the equipment to the mains sup- To remove the frost, follow the instructions below: ply. Switch off the appliance. www.zanussi.com...
Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The compressor operates contin- The temperature is not set correctly. Set a higher temperature. ually. The door is not closed correctly. Refer to "Closing the door". www.zanussi.com...
Page 8
Store less products at the same time. time. There is no cold air circulation in the Make sure that there is cold air circula- appliance. tion in the appliance. Replacing the lamp Caution! Disconnect the plug from the mains socket. www.zanussi.com...
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. www.zanussi.com...
Page 10
(shock) hazard. Ensure that it is disposed of safely. Door reversibility The door of the appliance opens to the right. If you want to open the door to the left, do these steps before you install the appliance: www.zanussi.com...
Page 11
Caution! Make sure that the mains cable can move until the upper gap cover freely. stops against the kitchen furniture. Do the following steps: Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. www.zanussi.com...
Page 12
D) to the lugs and the hinge holes. (E). Make sure to remove the part DX, in the case of Install the vent grille (B). Attach the hinge covers (E) right hinge, SX in opposite case. to the hinge. www.zanussi.com...