Table of Contents
Advertisement
Note
• When this function is turned on, use the
included ball point needle 75/11 for
embroidering patterns with short jump
stitches such as alphabet characters. Using
other needles may cause the thread to
break.
a
Press
.
b
Press
to turn off the thread trimming
function.
→ The key will display as
*
The machine will not trim the thread before moving
to the next stitching.
MAKING EMBROIDERY ADJUSTMENTS
■ Selecting the Length of Jump Stitch
Not to Trim
When the thread trimming function
on, you can select the length of the jump stitch not
to trim the thread. This function can be turned on or
off during embroidering.
Select a setting from 5 mm to 50 mm in 5 mm
increments.
*
Your customized setting remains after turning the
machine off and on.
Press
or
to select the length of jump stitch.
For example: Press
and the machine will not trim a jump stitch of 25
mm or less before moving to the next stitching.
Note
• If design has many trims it is recommended
to select a higher jump stitch trim setting in
order to reduce the amount of excess tails
on backside of fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the
machine will trim. In this case, more jump
stitches remain on the surface of the fabric.
Adjusting the Embroidery Speed
a
Press
.
b
In the "Max Embroidery Speed" display, use
to change the maximum
embroidery speed.
*
You can choose from 3 different speed levels, 350
spm, 600 spm or 1050 spm.
is turned
to select 25 mm (1 inch)
Embroidering E-33
E
1
Advertisement
Chapters
Table of Contents
Troubleshooting
