Table of Contents
Advertisement
GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Threading the needle manually
(without using the needle
threader)
When using specialty thread, such as transparent
nylon thread or metallic thread, a wing needle or a
twin needle which cannot be used with the needle
threader, thread the needle as described below.
a
Thread the machine to the needle bar thread
guide.
• For details, refer to "Threading the upper
thread" (page 20).
Lower the presser foot lever.
b
a
a Pressor foot lever
c
Pass the thread through the eye of the needle
from front to back.
CAUTION
● Do not touch the
(needle position button) or
reinforcement stitch button). If one of the
buttons is accidentally pressed, the machine
will begin sewing and your finger may be
pricked with the needle or the needle may
break.
d
Raise the presser foot lever, pass the end of
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
26
(start/stop button),
(reverse/
Using the twin needle
With the twin needle, you can sew two parallel lines
of the same stitch with two different threads. Both
upper threads should have the same thickness and
quality. Be sure to use the twin needle and the extra
spool pin.
For details on the stitches that can be sewn with the
twin needle, refer to "Stitch Settings" (page 89).
a
a Twin needle
b Extra spool pin
CAUTION
● Only use the twin needle (part code: X59296-
121). Use of any other needle may bend the
needle or damage the machine.
● Never use bent needles. Bent needles can
easily break, possibly resulting in injuries.
● The needle threader cannot be used with the
twin needle. If the needle threader is used
with the twin needle, the sewing machine
may be damaged.
Install the twin needle.
a
• For details on installing a needle, refer to
"Replacing the needle" (page 31).
b
Thread the upper thread for the left needle.
• For details, refer to steps
"Threading the upper thread" (page 20).
c
Manually thread the left needle with the
upper thread.
Pass the thread through the eye of the needle
from the front to the back.
b
a
j
through
of
Advertisement
Table of Contents
