hit counter script
Download Print this page

Advertisement

Available languages

Available languages

Connect the connector (white, 4pin) of power supply I/F harness to
the I/F connector (white, 4pin) of the main unit.
Remove the M4 screw shown in the illustration, insert the circle ter-
minal of ground harness, and it fixes again.
<3>Reattach the harness cover to its original position and fix it with the
removed screw.
At this time, ensure that the power supply I/F harness is arranged
as shown in the illustration.
• Fix the harness securely to the wire saddle.
Power supply
I/F harness
Wire saddle
6) Adjust the position of the paper guides of the upper paper tray of
the stand/paper drawer.
Refer to "Setting and adjustment" described later.
7) Carry out the off center adjustment.
Screw
Harness cover
Wire saddle
AR-D28/D27/MU2 UNPACKING AND INSTALLATION
3. AR-MU2
Front mounting plates:
2 pcs.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the main unit to the
"OFF" position.
Then, remove the power plug of the main unit from the outlet.
2) Put the main unit of the printer on the multi purpose drawer.
<1>Pull out the paper tray of the main unit until it stops and then
remove it by lifting both ends of the tray.
<2>Hold the main unit of the printer at the positions shown in the illus-
tration and put the main unit on the multi purpose drawer so that the
front side and the left side of the main unit are aligned to those of
the multi purpose drawer.
Caution: For installation of the main unit, it must be held by two
persons and installed without haste.
4 – 4
<Parts included>
Rear mounting plates:
Screws (M4x8):
2 pcs.
4 pcs.
"OFF"
Front side
Rear side

Advertisement

loading

This manual is also suitable for:

Ar-d27Ar-mu2