Switch# Configure Terminal; Switch(Config-If-Range)# Switchport Mode Access; Switch(Config-If-Range)# End - Cisco Catalyst 2960 Command Reference Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (788 pages)
Table of Contents
Advertisement
channel-group
For a complete list of configuration guidelines, see the "Configuring EtherChannels" chapter in the
software configuration guide for this release.
Examples
This example shows how to configure an EtherChannel. It assigns two static-access ports in VLAN 10
to channel 5 with the PAgP mode desirable:
Switch(config)# interface range gigabitethernet0/1 -2
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode desirable
This example shows how to configure an EtherChannel. It assigns two static-access ports in VLAN 10
to channel 5 with the LACP mode active:
Switch# configure terminal
Switch(config)# interface range gigabitethernet0/1 -2
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode active
Switch(config-if-range)# end
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands
Command
interface port-channel
Catalyst 2960 Switch Command Reference
2-28
Chapter 2
Restricts the protocol used on a port to manage channeling.
Accesses or creates the port channel.
Displays EtherChannel information for a channel.
Displays LACP channel-group information.
Displays PAgP channel-group information.
Displays the current operating configuration. For syntax
information, select Cisco IOS Configuration Fundamentals
Command Reference, Release 12.2 > File Management
Commands > Configuration File Management Commands.
OL-8604-03
- Quick Links:
- Cli Command Modes
Hide quick links:
Advertisement
Table of Contents
