Configure The Upstream Cisco Nexus 5000 Series Switch; Cisco Nexus 1100 Series Lom Ports Connected To Cisco Nexus 2248; Cisco Nexus 1100 Series Control, Packet, And Data Gigabit Ethernet Ports Connected To Cisco Nexus 2248 - Cisco Nexus 1110-S Deployment Manual
Nexus 1100 series
virtual services appliances
Table of Contents
Advertisement
Configure the Upstream Cisco Nexus 5000 Series Switch
The example presented here assumes that network connectivity option 3 is used with the Cisco Nexus 1100
Series. This example configures the two physical LOM interfaces on the Cisco Nexus 1100 Series to carry
management traffic as an active-standby pair, and it configures a PortChannel on two of the four 1 Gigabit Ethernet
Interfaces for control, packet, and data traffic. The PortChannels will allow only the necessary VLANs for the
environment. The configuration on the upstream Cisco Nexus 5548P Switch is shown here.
Cisco Nexus 1100 Series LOM Ports Connected to Cisco Nexus 2248
5548P-1# show run interface ethernet 100/1/37
!Command: show running-config interface Ethernet100/1/37
!Time: Tue Oct 23 17:51:12 2012
version 5.1(3)N1(1)
interface Ethernet100/1/37
switchport mode trunk
switchport trunk allowed vlan 172
spanning-tree port type edge trunk
5548P-1# show run interface ethernet 100/1/38
!Command: show running-config interface Ethernet100/1/38
!Time: Tue Oct 23 17:51:19 2012
version 5.1(3)N1(1)
interface Ethernet100/1/38
switchport mode trunk
switchport trunk allowed vlan 172
spanning-tree port type edge trunk
Cisco Nexus 1100 Series Control, Packet, and Data Gigabit Ethernet Ports Connected to Cisco Nexus 2248
5548P-1# show running-config interface port-channel 139
!Command: show running-config interface port-channel139
!Time: Tue Oct 23 18:10:44 2012
version 5.1(3)N1(1)
interface port-channel139
switchport mode trunk
switchport trunk allowed vlan 50
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 27 of 39
Hide quick links:
Advertisement
Table of Contents
