Interface Range - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Catalyst 2960 Switch Cisco IOS Commands

interface range

Use the interface range global configuration command to enter interface range configuration mode and

to execute a command on multiple ports at the same time. Use the no form of this command to remove

an interface range.

Syntax Description

This command has no default setting.

Command Modes

Global configuration

Command History

Usage Guidelines

When you enter interface range configuration mode, all interface parameters you enter are attributed to

all interfaces within the range.

For VLANs, you can use the interface range command only on existing VLAN switch virtual interfaces

(SVIs). To display VLAN SVIs, enter the show running-config privileged EXEC command. VLANs not

displayed cannot be used in the interface range command. The commands entered under interface

range command are applied to all existing VLAN SVIs in the range.

All configuration changes made to an interface range are saved to NVRAM, but the interface range itself

is not saved to NVRAM.

You can enter the interface range in two ways:

All interfaces in a range must be the same type; that is, all Fast Ethernet ports, all Gigabit Ethernet ports,

all EtherChannel ports, or all VLANs. However, you can define up to five interface ranges with a single

command, with each range separated by a comma.

interface range {port-range | macro name}

no interface range {port-range | macro name}

Port range. For a list of valid values for port-range, see the "Usage Guidelines"

Specify the name of a macro.

Modification

This command was introduced.

Specifying up to five interface ranges

Specifying a previously defined interface-range macro

Catalyst 2960 Switch Command Reference

interface range

Show Quick Links

Table of Contents