Managing The Switch Through The Cli; Other Management Options; Equipment That You Supply; Rack-Mounting And Switch Port Connections - Cisco ME 3400 Getting Started Manual
Ethernet access switches
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (950 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Disconnect the switch from the PC, and install the switch in your network. See the
Step 11
"Managing the Switch through the CLI" section on page 10 for information about
configuring and managing the switch.
If you need to rerun the initial configuration dialog, see the "Resetting the Switch" section
on page 20.
4
Managing the Switch through the CLI
After initially setting up and installing the switch in your network, you can enter Cisco IOS commands
and parameters through the CLI. Access the CLI either by connecting your PC directly to the switch
console port or through a Telnet session from a remote PC or workstation.
Other Management Options
You can use SNMP management applications such as CiscoWorks Small Network Management
Solution (SNMS) and HP OpenView to configure and manage the switch. You also can manage it
from an SNMP-compatible workstation that is running platforms such as HP OpenView or
SunNet Manager.
The Cisco IE2100 Series Configuration Registrar is a network management device that works with
embedded CNS agents in the switch software. You can use IE2100 to automate initial configurations
and configuration updates on the switch.
See the "Accessing Help Online" section on page 21 for a list of supporting documentation.
5
Rack-Mounting and Switch Port Connections
This section covers basic 19-inch rack-mounting and port connections. For alternate mounting
procedures, such as installing the switch in a 23-inch, 24-inch, or a European Telecommunication
Standards Institute (ETSI) rack, installing a switch on a wall, and for additional cabling information,
see the Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide or the Cisco ME 2400
Ethernet Access Switch Hardware Installation Guide on Cisco.com. The Cisco ME 3400G-2CS switch
mounts only in 19-inch racks.
Equipment That You Supply
You need to supply a number-2 Phillips screwdriver to rack-mount the switch. You must supply
alternative mounting hardware such as ETSI brackets or other hardware that does not ship with the
switch.
10
Hide quick links:
Advertisement
Table of Contents
