Table of Contents
Advertisement
ADSL2+ Gateway with VoIP
Call 1/2 FAX. Displayed here is the status of the fax pass-through mode.
Call 1/2 Type. Displayed here is the direction of the call.
Call 1/2 Remote Hold. This indicates whether the far end has placed the call on hold.
Call 1/2 Callback. This indicates whether the call was triggered by a call back request.
Call 1/2 Peer Name. Displayed here is the name of the internal phone.
Call 1/2 Peer Phone. Displayed here is the phone number of the internal phone.
Call 1/2 Duration. Displayed here is the duration of the call.
Call 1/2 Packets Sent. Displayed here is the number of packets sent.
Call 1/2 Packets Recv. Displayed here is the number of packets received.
Call 1/2 Bytes Sent. Displayed here is the number of bytes sent.
Call 1/2 Bytes Recv. Displayed here is the number of bytes received.
Call 1/2 Decode Latency. Displayed here is the number of milliseconds for decoder latency.
Call 1/2 Jitter. Displayed here is the number of milliseconds for receiver jitter.
Call 1/2 Round Trip Delay. Displayed here is the number of milliseconds for delay.
Call 1/2 Packets Lost. Displayed here is the number of packets lost.
Call 1/2 Packet Error. Displayed here is the number of invalid packets received.
Call 1/2 Mapped RTP Port. Displayed here is the number of the NAT mapped RTP port.
PSTN Line Status
Hook State. Displayed here is the status of the LINE port. On indicates that it is ready for use, while Off indicates that it is in
use.
Line Voltage. Displayed here is the tip-to-ring voltage of the LINE port.
Loop Current. Displayed is the loop current to the LINE port.
Registration State. Shown here is the status of the line's registration.
Last Registration At. Shown here are the last date and time the line was registered.
Chapter 6: Configuring the ADSL2+ Gateway
27
The Setup - Voice Tab
Advertisement
Table of Contents
